Cayman (987) F6-2.9L (2009)
1. If a new power window motor is to be installed, read out the values first. Refer to Removing and installing power window motor.
Switch off ignition and remove ignition key.
INFORMATION: On "newer" power window motors, the wire harness from the door wiring harness is clipped in on the power window motor.
-
Use a screwdriver to unclip the wire harness from the clip above the power window motor.
A new connector concept is used on newer power window motors. Procedure:
-
Release (pull out) the red lock on the connector using a screwdriver.
-
Release the locking lug underneath and pull the connector off the power window motor.
2. Unlock electric connector -a- and disconnect from power window motor.
3. Unscrew the three fastening screws -1-.
4. Pull the power window motor out of the teeth.
Installing power window motor
INFORMATION: On "newer" power window motors, the wire harness from the door wiring harness is clipped in on the power window motor.
-
Clip in wire harness on the power window motor.
1. Position power window motor and push into the teeth.
2. Screw in the three fastening screws. Tightening torque: 3 Nm (2 ftlb.)