Cayman (987) F6-2.9L (2009)
4. Push the white hose -1- onto the control valve for lumbar support -2-.
Checking seat following removal
1. Connect the removed seat to the vehicle's wiring harness via test cable 9745 and test cable 9745/1.
2. Connect electric plug to control module trim panel. Refer to Removing and installing control module trim panel.
3. Connect the battery. Refer to Work instructions after disconnecting the battery.
4. Switch on ignition.
5. Carry out a function check on the seat components.
6. Switch off ignition after function test and disconnect battery.
7. Disconnect test cable 9745 and test cable 9745/1.
Fitting foam part
INFORMATION:
-
Observe the installation position of the hoses.
-
Make sure that the hoses are not pinched. Insert hoses exactly into the cut-outs on the foam part.
1. Fit foam part -1- at the headrest.
Installing support for left backrest side part
INFORMATION:
-
Observe hose routing.