Cayman (987) F6-2.9L (2009)
-
Mark upper mounting point with the dimensions -A=95 mm- and -B=50 mm-.
-
Mark lower mounting point with the dimensions -C=25 mm- and -D=155 mm-.
1. Position seat-belt guide -1- with sleeve -5- with the aid of the marking on the backrest cover.
2. Tighten fastening screw -3- with spacer -4-.
3. Press in -2- cap
4. Position push button -3- with the aid of the marking on the backrest cover -Arrow A- and screw down with the fastening screw -2-.
5. Press seat-belt guide -1- into push button -3- at top -Arrow B-.
Subsequent work
Removing creases in seat cover (leather)
CAUTION: Risk of damage to cover if excessive heat is applied.
-
Creases in cover
-
If creases have formed, only short partial warming with the hot-air gun is permissible.
-
The hot-air temperature always must be 50° C.
1. If creases have formed, partially heat the affected areas of the cover with the hot-air gun and smooth out the cover using the special tool.
Scudding knife P 9747