Cayman (987) F6-2.9L (2009)
INFORMATION: If the engine is replaced, the lines from the engine to the microswitch must be pinched off and crimped on with the lines from the
new engine.
2. Cut off the lines between the engine and the microswitch to a suitable length.
3. Pull out axle -A- and remove spur gear -B-.
Installing engine for rear spoiler
Installing motor for rear spoiler
1. Insert spur gear -B- and push in axle -A-.
2. Position motor for spoiler drive -2- and screw down using the three fastening screws -1-. Tightening torque: 6 Nm (4.5 ftlb.)