Cayman (987) F6-2.9L (2009)
B - Distance from logo to edge of lid (standard) = 66.1 mm/"S" = 60.1 mm
1.3.1
Remove traces of weathering from the old logo/logos using paint polish if necessary.
Information
Clean bonding surface to remove any dust and grease.
1.3.2
Apply new logos on rear lid.
1.4 Remove both tail lights --> Workshop Manual '943120 Removing and installing tail lights - section on "Removing".
1.5 Remove spoiler drive and both sealing plates (left side --> Figure 4-A-). Workshop Manual '667219 Removing and installing spoiler drive -
section on "Removing"'.
1.6 Clean rear apron underneath removed standard spoiler.
1.7 Wrap adhesive tape around connector for spoiler drive (6-pin) and secure it to existing components/lines in the luggage compartment so that it
cannot become chafed and will not rattle (--> Figure 5 -arrows-).
1.8 Fit two rubber stoppers in the bores on the luggage compartment floorpan (water drain mechanism for standard spoiler) (left side, --> Figure
5-A-).
1.9 Remove trim panel for rear lid --> Workshop Manual '708719 Removing and installing trim panel for rear lid - section on "Removing"'.
2
Prepare rear lid for installing rear spoiler
2.1 Drill bore holes for rear spoiler on the rear-lid outer panel.
2.1.1
Open the rear lid and cover the luggage compartment with brown paper or a similar protective covering.
2.1.2
Spray water on the surface of the rear lid using a spray bottle.