Cayman (987) F6-2.9L (2009)
5.2.1
Guide mounting plate (--> Figure 25-A1-) into the cavity in the rear wall/end plate and position it correctly.
5.2.2
Slide sealing plate (--> Figure 25 -B1-) onto both pins with foam rubber facing the rear wall of the luggage compartment and fit M6 hexagon
nut (--> Figure 25 -B2-).
5.2.3
Tighten M6 hexagon nut.
Tightening torque 4.5 Nm (3.0 ft.lb.)
5.3 Install trim panel for rear lid --> Workshop Manual '708719 Removing and installing trim panel for rear lid - section on "Installing"'.
5.4 Install both tail lights --> Workshop Manual '943120 Removing and installing tail lights - section on "Installing"'.
5.5 Install cover for rear lock support --> Workshop Manual '703919 Removing and installing cover for rear lock support - section on 'Installing"
5.6 In stall trim panel for rear luggage compartment --> Workshop Manual '700619 Removing and installing trim panel for rear luggage compartment
(carpet lining) - section on "Installing"'.
6
Fit front spoiler lip.
6.1 Drive the vehicle onto a lifting platform and raise it to working height --> Workshop Manual '400000 Lifting the vehicle'.
6.2 Remove the two standard spoiler lips (--> Figure 26-1-) --> Workshop Manual '660319 Removing and installing front spoiler - section on
"Removing"'.
6.3 Clean around the spoiler lips (--> Figure 26 -1-, shaded area) on the front apron.
6.4 Install the two new spoiler lips (--> Figure 26 -2-) --> Workshop Manual '660319 Removing and installing front spoiler - section on 'Installing"'
7
Concluding work
7.1 Code "Fixed spoiler" using the PIWIS Tester 9718.
7.1.1
Select "Rear" control unit group and press [>>].
7.1.2
Select "Coding" menu item and press [>>].
7.1.3
Select "Fixed spoiler - not installed" in the menu and change the coding by pressing [>>].
7.1.4
Switch from "not installed" to "installed" under "Change coding".
7.1.5
Write coding with [F8].
7.2 Read out the fault memory of all control units, correct any existing faults, and then erase the fault memory.