Cayman (987) F6-2.9L (2009)
Bellows
2. Connect the push rods. Use a new lock nut -Arrow- to do this.
Push rod mount
Information
^
Adjusting the brake push rod length changes the position of the brake pedal.
^
If the brake pedal is not at the correct position, the brake push rod must be adjusted slightly.
^
Check the brake light switch setting.
3. Check the position of the brake pedal and adjust it if necessary (Dimension X = 48 +2 mm). Measure between the brake pedal plate and the
accelerator pedal.
Fine adjustment for brake push rod (Dimension X = 48 +2 mm): Undo the lock nut -1- and turn the push rod as required at the hexagon -2-, then
set the dimension -X-. Tighten the lock nut -1-.
Brake pedal position
4. Fit the bellows and secure it to the body with a clamp -Arrow-.