Cayman (987) F6-2.9L (2009)
1. Fasten the special tool retaining device 9607 onto the workbench using two screw clamps.
2. Mark connecting rod 4-6 in the installation position.
3. Remove connecting rods on cylinder side 4-6 one after another. Loosen the two connecting rod bolts on each connecting rod, remove connecting
rod cap. Using a plastic mandrel (possibly an in-house tool) push connecting rod down and out. Immediately after this, screw on loosely to
associated connecting rod cap. Place on a clean surface.
Plastic mandrel
4. Loosen 14 M9 x 127 screws for the gear carrier in the opposite order to the tightening sequence, from the outside inwards, and unscrew them.