Cayman (987) F6-2.9L (2009)
Gear carrier half 4-6 on device
2. Ensure that the dowel sleeves are seated correctly in gear carrier half 4-6.
Dowel sleeves, gear carrier 4-6
3. Insert three oil spray jets in the take-up bores in each of the gear carrier halves, press in gently to the stop using a plastic mandrel (diameter 4 mm
).
Oil spray jets for piston cooling
4. Insert two thrust washers onto the center thrust block (No. 4) of gear carrier half 4-6; when doing so, the oil pockets -Arrows- must always point
outwards (to the belt pulley side or flywheel side).