Cayman (987) F6-2.9L (2009)
Removing triggering unit for airbag
WARNING: Incorrect triggering of airbag modules.
-
Danger of injury and material damage to as a result of incorrect handling of airbag units.
-
Remove ignition key. Disconnect battery. Route or isolate ground strap so that all contact with a ground carrier (e.g. body, seat frame) is
avoided. Refer to Work instructions after disconnecting the battery.
-
Before disconnecting the airbag plug from the triggering unit, always wait for one minute after disconnecting the battery.
-
The airbag triggering unit must not be removed with the connector still plugged in.
Incorrect triggering of airbag modules.
1. From the passenger's side, release electric plug -a- and open the latching lever -arrow-.
2. Unscrew the three fastening screws -1-.
3. Take off both ground straps -2- from the bolt for the triggering unit.
4. Remove triggering unit laterally.
Installing triggering unit
INFORMATION: If a new component (e.g. sensor, airbag control unit, airbag unit) of the airbag system has to be installed, the new component will be
supplied with a barcode sticker (tear-off label).