Cayman (987) F6-2.9L (2009)
28.1. Position transfer point, lead to terminal 30, in installation position.
28.2. Insert both spacer sleeves -2-.
28.3. Fix both fastening nuts -1-. - Contact force: 10 Nm
29. Position starter lead -28 and 29- for terminal 30 and terminal 50 and secure with fastening nut. - Tightening torque: 18 Nm (13 ftlb.). - Tightening
torque: 6.5 Nm (5.0 ftlb.)
30. Plug on connector at coolant temperature sensor -27- until it engages securely.
31. Push on connectors of the two knock sensors -25 and 26- until they are felt to engage.
32. Push on connectors of the two solenoid hydraulic valves (camshaft timing -23 and 24- until they are felt to engage.
33. Push on connectors of the two solenoid hydraulic valves (VHS) -21 and 22- until they are felt to engage.
34. Push on connectors of the two hall senders -19 and 20- until they are felt to engage.
35. Fix ground straps on the six ignition coils -13 bis 18-.
35.1. Position ground straps -1- and screw down with the fastening screw. - Tightening torque: 9 Nm
36. Push on connectors of the six fuel injectors -7 bis 12- until they are felt to engage.
37. Push on connectors of the six injector coils -1 bis 6- until they are felt to engage.
Subsequent work
1. Install rear cover.
2. fit rear wheels.
3. Install intake-air distributor.
4. Install rear wall cover.
5. Install DME control unit.
6. Install rear luggage-compartment lining.
7. Carry out work instructions after disconnecting the battery.
Removing and Installing Wire Harness For Front-End
Removing And Installing Wire Harness For Front-end
Technical values
Preliminary work
1. Disconnect battery.
2. Remove luggage compartment linings
3. Remove front-end control unit.
4. Remove left and right headlight.
5. Remove front apron.