Cayman (987) F6-2.9L (2009)
5. Pull off connector and plug connection on control unit for coolant control -7 to 9-.
5.1. Release and remove plug connection to coolant fan -7-.
5.2. Release and remove connector on control unit for coolant control -8 and 9-.
6. Unclip cable guide for sensor line for front airbag -10-.
7. Release connectors on both sensors for front airbag -11- and pull them off.
8. Unclip front-end wire harness on right side at tie-wraps -22-.
9. Unclip front-end wire harness on left side at holders -23-.
INFORMATION: Only for USA/Canada version vehicles.
10. Release connector on front emergency release -12- and pull it off.
11. Release connector for outside temperature sensor -13- and pull it off.
12. Release connectors on both horns -14 and 15- and pull them off.
13. Release and pull off connector on servo motor for front lid release -16-.
14. Release and pull off connector on control unit for garage door opener/HomeLink -17-.
15. Unclip front-end wire harness on right side at tie-wraps -22-.
16. Release and disconnect plug connection on microswitch for lower part of front lid lock -18-.
17. Release connector on servo motor for front lid -19- and -arrows a- pull it off.
18. Release plug connection for front-end wire harness to main wire harness, left -20- and disconnect.
19. Pull off holders -24-.
20. Remove the three grommets -21- and pull the wire harness through the openings in the body.
21. Remove wire harness for front-end.
Installing wire harness for front-end
INFORMATION:
-
The wire harness for front end spare parts scope means the scope for fully-equipped vehicles. Depending on the vehicle equipment, connectors not
required are tied to the wire harness for front end using tie-wraps.
-
When doing this, ensure the lines are routed correctly so that no line becomes trapped or damaged.