Cayman (987) F6-2.9L (2009)
Steering Gear: Service and Repair
Removing and installing power-steering gear
Preliminary work
1. Raise the vehicle.
2. Remove front wheels.
3. Remove front underbody panel.
General warning notes
Caution
Increased risk of accidents if too much Pentosin is used or if Pentosin comes into contact with the coolant hoses when filling or topping up.
Possible danger of injury or damage.
-
Multiple steering operations (maneuvering) with the engine switched off change the fluid level in the reservoir. In this case, the engine must be
running immediately prior to the fluid level check.
-
If coolant hoses come into contact with Pentosin, clean them thoroughly with water IMMEDIATELY.
-
Replace visibly swollen coolant hoses.
Information
Before the feed and return lines are loosened, place a suitable container underneath to collect steering fluid.
Wear protective goggles and gloves.
Removal
Removing power-steering gear
Information
Fix the steering wheel with the wheels in straight-ahead position or remove the steering wheel with the wheels in straight ahead position. If this is not
done, the airbag contact unit will have to be put in centre position after installation of the steering gear.
1. Loosen universal joint (steering shaft) on steering gear -Arrow-. To do this, take out the clamping screw and slide the joint upwards.