Cayman (987) F6-2.9L (2009)
Sensor
Fit sensor on control arm and connect electric plug connection.
Cross member
Insert electric plug connection in holder -arrows-.
3. Install eccentric threaded joints (toe and transverse control arm) at rear-axle carrier side section.
Rear-axle carrier side section
3.1.
Install toe eccentric threaded joint between transverse strut and rear-axle carrier side section.
Set the basic position of the toe eccentrics at the marked position -see arrow- on the rear-axle carrier side section and tighten nuts.
3.2.
Install camber eccentric threaded joint between toe control arm and rear-axle carrier side section.
Set the basic position of the toe eccentrics at the marked position -see arrow- on the rear-axle carrier side section and tighten nuts.
4. Insert support plate and align rear-axle carrier side section.
Securing support plate
Insert the support plate and secure it to the following components, see -arrows-:
Rear-axle carrier side section, cross member, V-brace
Align rear-axle carrier side section as required until the hole patterns are perfectly matched. It must be possible to insert the support plate without
tension.
5. Tighten screws on rear-axle carrier side section and cross member.
5.1.
Tighten screws securing rear-axle carrier side section to body. - Tightening torque: 65 Nm (48 ftlb.)
5.2.
Tighten screws securing cross member to rear-axle carrier side section. - Tightening torque: 65 Nm (48 ftlb.)
6. Install transmission bracket with hydraulic mount.
6.1.
Tighten screws securing transmission bracket to transmission.