Cayman (987) F6-2.9L (2009)
ATF pan
2. Tighten the ATF pan -1- in the prescribed sequence - see figure
Information
The aluminium screws on the Porsche Doppelkupplung must be tightened according to a yield strength-controlled tightening procedure using an
electronic torque wrench 9768.
To ensure that the screws are tightened uniformly, the corresponding tightening setting "light, medium or hard" must always be used.
Tighten M6 screws at "medium" setting.
-
Tightening torque: 2.4 Nm (2 ftlb.)
3. Fit anti-roll bar on rear-axle carrier side section.
Anti-roll bar
Move anti-roll bar -2- into position and screw in and tighten M8 x 40 screws -1-.
-
Tightening torque: 23 Nm (17 ftlb.)
4. Install support plate.