Cayman (987) F6-2.9L (2009)
Pressing off CV joint
3. Remove outer bellows.
Outer CV joint
3.1.
Remove clamp and/or clip (depending on design) -1 and 2-.
3.2.
Push the bellows off the profile shaft. Then force off the cap -3- and bellows holder -4- evenly using a suitable mandrel.
4. Grease CV joints.
Regrease the CV joints with special grease if necessary. On the wheel-side joint, press -special grease- through the bellows holder into the joint.
Greasing CV joint
Do not remove bellows holder on wheel-side joint.
The CV joints must be able to be move slightly in an axial direction (length compensation).
5. Push inner and outer bellows and clamps or clips onto profile shaft.
6. Install CV joints.
6.1.
Push or press the CV joint onto the correct position on the profile shaft using a suitable pressure piece -3-.