Cayman (987) F6-2.9L (2009)
1. Replace the circlip for the halfshaft flange. To do this, clamp the halfshaft flange in a vice using a screw -B- and press out the circlip with the new
circlip -A-.
Replacing circlip
2. Grease circlip and drive in halfshaft flange using a rubber hammer.
3. Fit right drive shaft on transmission side. To do this, screw in the six Allen screws joining each drive shaft and transmission flange and tighten
screws. Counter at the wheel or activate the parking brake to avoid simultaneous turning.
Drive shaft
Subsequent work
1. Check transmission oil and, if necessary, top up.
2. Fit support plate.
3. Lower the vehicle.