Cayman (987) F6-2.9L (2009)
Checking halfshaft flange
2.1.2.
Fit the mounting saddle -2- using a long halfshaft flange -1-.
Long halfshaft flange
2.2.
Tighten the mounting saddle.
Long halfshaft flange
Fit mounting saddle and screw in screws. Use an electronic torque wrench 9768 to tighten the screws in the sequence -1 to 5-.
Always use new aluminium screws. Blow out threaded bore thoroughly with compressed air.
Tighten M8 screws at "medium" setting.
-
Tightening torque: 6 Nm (4.5 ftlb.)
2.3.
Drive in long drive shaft flange by tapping lightly with a hammer (rubber hammer).