Cayman (987) F6-2.9L (2009)
3. Secure the wiper motor with the three fastening screws -2- to the wiper link. - Tightening torque: 6 ftlb.
4. Screw down the fastening screw -3- for the wiper link. - Tightening torque: 7.5 ftlb.
5. Connect battery, ignition on, and actuate wiper motor.
6. Allow wiper motor to run in parking position. Place the link on the drive on the wiper motor. Place fastening nuts -1-. The installation position of
the link is identified by a 0 marking (parking position) on the console.
7. If the position -0- matches, then screw down the fastening nut -1-. - Tightening torque: 13 ftlb.
8. Connect the battery.
9. Switch on the wiper motor and check the wiper position.
Subsequent work for wiper motor
Touching up wiper motor
-
Left plenum chamber cover
-
Carry out work instruction after disconnecting the battery.