Cayman S (987) F6-3.4L (2008)
5. Insert primary chain tensioner with new sealing ring (hexagon a/f 32) and tighten to the specified torque. Tightening torque: 80 Nm (59 ftlb.)
6. Insert chain tensioner for cylinder 1-3 with new sealing ring (hexagon a/f 32) and tighten to the specified torque. -> Tightening torque: 80 Nm (59
ftlb.)
7. Fasten coolant pipes on cylinder side 1-3 with two M6 x 12 hexagon-head bolts. Tightening torque: 10 Nm (7.5 ftlb.)
8. Fit two new closure caps on cylinder head cover.
9. Pull locating pin out of crankshaft belt pulley.
Installing bearing cover for intermediate shaft - from engine number 62.504095
Caution
Risk of damage due to particles of dirt.
^
Danger of material damage due to blocked oil bores/oil ducts.
-> Absolute cleanliness is essential when working on the engine.
-> Lay removed engine parts on a clean base and make sure to cover them.
-> Use the cover for dust protection when fitting the engine NR.165 on the engine assembly support.
Note
^
The same sealing ring and installation/removal procedure applies as for the "old" bearing cover.