Cayman S (987) F6-3.4L (2008)
Preliminary work
Preliminary work for line condenser-condenser
Removing front apron.
Draining refrigerant.
Removing the condenser-condenser line
1. Unscrew the two fastening screws -1- holding the air guide for the condenser.
2. Pull the air guide forward and disengage it at the condenser -A-.
3. Unscrew the fastening nuts for both holders line, open the holder and take out the line.
INFORMATION:
-
When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.