Cayman S (987) F6-3.4L (2008)
/f6-3.4l/Page-468013.png)
1.1. Release plug connections for main wire harness to rear wire harness -arrows A- and disconnect.
2. Disconnect plug connections for main wire harness to engine wire harness -35 and 36-.
2.1. Release plug connections for main wire harness to engine wire harness -arrows A- and disconnect -arrows B-.
2.2. Release sockets for main wire harness -arrows C- and push down from relay carrier -arrows D-.
3. Release connector for rear vertical sensor -37- and pull it off.
4. Release and pull off connector on DME control module -38 and 39-.
5. Loosen ground point in luggage compartment -40-.
5.1. Screw off fastening nut and remove ground strap.
6. Release and pull off connector on rear angle sensor for headlight beam adjustment -41-.
7. Remove rubber sleeves -42-.
