Cayman S (987) F6-3.4L (2008)
4. Pull the power window motor out of the teeth.
Installing power window motor
INFORMATION: On "newer" power window motors, the wire harness from the door wiring harness is clipped in on the power window motor.
-
Clip in wire harness on the power window motor.
1. Position power window motor and push into the teeth.
2. Screw in the three fastening screws. Tightening torque: 3 Nm (2 ftlb.)
3. Press in electric connector on power window motor until it engages securely.
INFORMATION: The end positions of the power windows are deleted from the control unit when the electric connectors are disconnected and
connected.
4. Operate rocker switch and fully close window once.
5. Operate rocker switch to close again. The upper end position of the side window is stored.
6. Operate rocker switch and fully open window once.
7. Operate rocker switch to open again. The lower end position of the side window is stored.
8. If a new power window motor has been installed (door control unit), this must be programmed/coded.
-
Refer to Removing and installing power window motor.