Panamera 4S (970) V8-4.8L (2011)
6. Unscrew plastic nut -2- at the centre rear of the wheel housing liner.
7. Unscrew plastic nuts -2- on the centre front of the wheel housing liner.
8. Remove wheel housing liner.
Installing rear wheel housing liner
1. Place the wheel housing liner in installation position.
2. Screw in plastic nuts -2- on the inside of the wheel housing liner.
3. Screw in fastening screw -1- securing the inside of the wheel housing liner to the heat protection panel.
4. Screw in plastic nut -2- at the centre rear of the wheel housing liner.