Panamera 4S (970) V8-4.8L (2011)
/v8-4.8l/Page-51010.png)
5.5. Fit lines (vacuum, tank vent, fuel) and plastic clip. -4 and 5- Fit (clip in) the plastic clip on the strut.
6. Fit centre plenum panel wall at the top.
6.1. Guide the centre plenum panel wall at the top in sideways under the wiring harness and pull the vacuum line through the bore in the grommet.
Fit the grommet. -> Guiding vacuum line through the plenum panel wall
6.2. Align the centre plenum panel wall at the top and move it into installation position. Fit the fastening screws. -> Centre plenum panel at the top
7. Attach vacuum line to the vacuum pump. -3-
8. Fit engine wiring harness with rubber sleeve (seal) into the plenum panel wall. -2-
