Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-860003.png)
4. Repeat steps 2 to 4 to assign further buttons.
Storing garage door opener signal on button with variable code system
INFORMATION:
Check operating instructions for the garage door drive (or other system) for specification of a variable code.
If the garage door opener control unit has been programmed to a variable code system, it will still have to be synchronised with this system on
completion of programming before it will work correctly.
1. The standard codes set in the factory must be erased first before any signals can be stored.
2. Press the required button until the LED flashes slowly. You then have around 5 minutes to complete steps 3 and 4.
