Panamera S (970) V8-4.8L (2010)
Wear area B
-
Measure the brake discs with a suitable micrometer at a minimum of three different places ( -A, B, C- ), offset by 120 degrees.
Measurement points for brake disc thickness
Checking lateral runout (brake disc/wheel hub) and thickness tolerance
Information
Fasten dial gauge set with ball joint arm to wheel bearing housing.
Two adapters are used for checking lateral runout. The brake disc and wheel hub can be measured with these.
Brake disc lateral runout
1. Remove the wheel and fit the adapter plate 9510/1 with tightening torque 160 Nm (118 ftlb.).
Adapter plate on wheel hub
2. Fit the adapter dial gauge set with ball joint arm Nr.147-1 at a suitable position on the wheel bearing housing (schematic representation of front
axle).