Panamera S (970) V8-4.8L (2010)
Piston, connecting rod
3. Remove the remaining pistons using the same procedure. To do this, turn the crankshaft using a wrench (a/f 27).
Installing pistons
Information
*
Connecting rod bolts and bearing shells must always be replaced.
*
The marking on the main bearings and connecting rod bearings is located on the flywheel flange of the crankshaft.
Information
*
The pistons must already be pre-fitted (pistons, piston rings, connecting rods and fastening material) before performing the next step.
*
Fit the number on the connecting rod -A- facing the exhaust side.
*
When installing the piston in the crankcase, the direction of travel arrow on the piston crown must point in the direction of travel.
Surface with cylinder number marking
*
The code on the connecting-rod big end and connecting rod cap must be on the same side -A-.
Allocation