Panamera S (970) V8-4.8L (2010)
Disconnecting expansion hose
1.1.
Open the clamps -2-.
1.2.
Remove expansion hose and let it hang down.
2. Place a drip pan under the oil/coolant heat exchanger. (Coolant and oil will run out during disassembly.)
3. Disconnect coolant hoses.
Removing coolant hoses
3.1.
Loosen the clips -1- on the coolant hoses at the oil/coolant heat exchanger and slide them onto the hoses -A-.
3.2.
Clamp the hoses using hose clamp 3093 or hose clamp 3094.
3.3.
Clip the coolant hose assembly -3- on the oil/coolant heat exchanger from the holder -2- ( -B- ).
3.4.
Pull off the hoses -C-.
4. Unscrew fastening screws -1-.
Fastening screws for oil/water heat exchanger
5. Tilt the oil/coolant heat exchanger up in direction of travel -A-.
6. Remove the oil/coolant heat exchanger.
Installing oil/water heat exchanger
Information