Panamera S (970) V8-4.8L (2010)
1 - Coolant pump
2 - Seal; rubber seal fitted in coolant pump
3 - Screw, M6 x 25 => For tightening sequence, see below
A - Direction of travel
Tightening sequence for coolant pump
V6 coolant pump
Removing coolant pump
Information
*
To ease removal, spray the pulley from the rear side with an anti-corrosion agent.
1. Loosen the three fastening screws on the coolant pump pulley. -Arrows- Block pulley with a holder Nr.38 or brace Nr.193 if necessary or if the
belt drive is removed.
Fastening screws for coolant pump pulley
2. Detach drive belt from water pump.