Panamera S (970) V8-4.8L (2010)
1. Release the latch on the connector -a- and pull the connector off the voltage transformer for the Start/Stop function.
2. Unscrew the two fastening nuts -2- and remove the voltage transformer for the Start/Stop function -1-.
Installing voltage transformer for Start/Stop
1. Position voltage transformer for the Start/Stop function -1- on the holder and secure in place with the two fastening screws -2-. -> Tightening
torque: 6 Nm (4.5 ftlb.)+10 %-20 %
Plugging in connector
2. Plug in and lock electric connector on voltage transformer for Start/Stop function -a-.
Subsequent work
Subsequent work for voltage transformer for Start/Stop
1. Fit tool kit tray.
2. Close the luggage compartment floor.
3. If the voltage transformer for the Start/Stop function was replaced, the values/coding must be written back into the control unit again.