Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-429002.png)
3.
Release electric connector -a- and pull it off the ignition switch.
Installing ignition switch
1. Connect plug on ignition switch until it clicks into place.
2. Position ignition switch in the dashboard from below -arrow D-. Position union nut -1- and slide over the ignition switch. Pay attention to the fitted
shape. Use the special tool key 9800 to tighten the union nut -1-. -> Tightening torque: 1.6 Nm (1 ftlb.)
Subsequent work
1. Install moulding for left driver-side dashboard.
2. Install steering column trim.
