Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-799007.png)
2. Disconnect both connectors from the airbag unit and first plug in the connector -D- - 1st stage - from the adapter cable 9257/7 at the airbag unit on
the right.
INFORMATION: This is a two-stage airbag module with the right connection - 1st stage - and the left connection - 2nd stage.
3. Connect the ignition device 9257 to the 2-pin connector -F- of the adapter cable 9257/7.
4. Place the ignition device in front of the vehicle through the door gap.
5. After triggering, repeat the work step on the left airbag unit with connector -E- - 2nd stage.
Side airbag
WARNING:
Incorrect handling of airbag units
-
Triggering of airbag unit
-
System faults can occur
-
Switch off ignition and remove ignition key.
-
A voltage supply (e.g. battery charger) must not be connected to the external power supply/jump-lead starting terminals.
-
Disconnect the battery and insulate the ground strap so that all contact with a ground carrier is avoided.
-
Wait 1 minute after disconnecting the battery.
-
Only pull off connector on the triggering unit after the waiting time has elapsed.
-
Make sure that no foreign objects are located in front of the airbag unit during installation.
-
Replace damaged parts during removal.
-
Always position the airbag unit in such a way that the airbag opening is facing upwards.
-
If removed for an extended period, the airbag unit must be stored in a safe place.
-
Airbag units must not come into contact with grease, oil, detergents, liquids, or similar substances.
-
Do not expose airbag units to temperatures above 90°.
-
Do not remove the short-circuit spring on the plug-in contacts.
-
Ignition and preparations may only be carried out by skilled staff, supervised by a second responsible person.
-
Before disposal, the airbag unit must be rendered harmless by electrical ignition performed in accordance with all precautionary measures, thereby
preventing it from being used incorrectly.
INFORMATION:
Only ignite airbag units that are securely installed in the vehicle and in the original condition. Allow airbag units to cool down under observation
following ignition.
-
Use only the ignition tool intended for this purpose. First remove all loose objects from the expansion area of the airbag.
-
Every ignition circuit for all airbag units and seat-belt tensioners must be ignited individually.
-
Persons possibly affected must be informed of the resulting noise beforehand.
-
Wear ear protectors.
-
Keep a safe distance by utilising the entire cable length of the ignition tool. Do not connect the voltage source until all other preparations are
complete.
-
If ignition fails, wait for approx. 3 minutes before approaching the vehicle.
-
Carry out ignition only in suitable, open areas.
-
Avoid skin contact with ignited airbag units.
Adapter cable 9257/6
