Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-803003.png)
1. Release -a- and unplug electric plug connection.
2. Loosen fastening nut -1- and take off sensor.
Removing wheel arch sensor
WARNING:
Incorrect handling of airbag units
-
Triggering of airbag unit
-
System faults can occur
-
Switch off ignition and remove ignition key.
-
A voltage supply (e.g. battery charger) must not be connected to the external power supply/jump-lead starting terminals.
-
Disconnect the battery and insulate the ground strap so that all contact with a ground carrier is avoided.
-
Wait 1 minute after disconnecting the battery.
-
Only pull off connector on the triggering unit after the waiting time has elapsed.
-
Make sure that no foreign objects are located in front of the airbag unit during installation.
-
Replace damaged parts during removal.
-
Always position the airbag unit in such a way that the airbag opening is facing upwards.
-
If removed for an extended period, the airbag unit must be stored in a safe place.
-
Airbag units must not come into contact with grease, oil, detergents, liquids, or similar substances.
-
Do not expose airbag units to temperatures above 90°.
-
Do not remove the short-circuit spring on the plug-in contacts.
-
Ignition and preparations may only be carried out by skilled staff, supervised by a second responsible person.
-
Before disposal, the airbag unit must be rendered harmless by electrical ignition performed in accordance with all precautionary measures, thereby
preventing it from being used incorrectly.
INFORMATION:
-
6 sensors are used for the airbags in the Panamera.
-
The front two sensors are located on the lock support.
-
The middle two sensors are located on the door sill behind the A-pillar.
-
The rear two sensors are located on the rear wheel housings.
1. Release -a- and unplug electric plug connection.
2. Loosen fastening nut -1- and take off sensor.
Installing airbag sensor
Installing sensor on lock support
WARNING:
Incorrect handling of airbag units
-
Triggering of airbag unit
-
System faults can occur
-
Switch off ignition and remove ignition key.
-
A voltage supply (e.g. battery charger) must not be connected to the external power supply/jump-lead starting terminals.
