Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-821006.png)
INFORMATION:
-
Make sure that the sensor is properly positioned.
-
Always replace the fastening screws and nuts after customer service and reworking. The micro-self-locking screws must not be treated, greased or
loosened and then screwed on again.
2. Place the sensor in position and secure using the fastening nut -1- .
-
Tightening torque: 9 Nm (6.5 ftlb.)+1 Nm (+0.5 ftlb.)-1.5 Nm (-1 ftlb.)
Installing wheel arch sensor
WARNING:
Incorrect handling of airbag units
-
Triggering of airbag unit
-
System faults can occur
-
Switch off ignition and remove ignition key.
-
A voltage supply (e.g. battery charger) must not be connected to the external power supply/jump-lead starting terminals.
-
Disconnect the battery and insulate the ground strap so that all contact with a ground carrier is avoided.
-
Wait 1 minute after disconnecting the battery.
-
Only pull off connector on the triggering unit after the waiting time has elapsed.
-
Make sure that no foreign objects are located in front of the airbag unit during installation.
-
Replace damaged parts during removal.
-
Always position the airbag unit in such a way that the airbag opening is facing upwards.
-
If removed for an extended period, the airbag unit must be stored in a safe place.
-
Airbag units must not come into contact with grease, oil, detergents, liquids, or similar substances.
-
Do not expose airbag units to temperatures above 90°.
-
Do not remove the short-circuit spring on the plug-in contacts.
-
Ignition and preparations may only be carried out by skilled staff, supervised by a second responsible person.
-
Before disposal, the airbag unit must be rendered harmless by electrical ignition performed in accordance with all precautionary measures, thereby
preventing it from being used incorrectly.
WARNING:
Incorrect handling of safety bolts
-
Danger of injury
-
Loss of torque
-
Always use new fastening screws and nuts following removal.
-
Observe specified tightening torques.
-
Carry out a visual inspection of all re-used parts.
INFORMATION: If a new component (e.g. sensor, airbag control unit, airbag unit) of the airbag system has to be installed, the new component will
be supplied with a bar code sticker (tear-off label).
