Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-105003.png)
the windscreen with a hot-air gun or similar.
-
Contact surface must be free of grease and dirt.
-
The sensor on the silicone surface must not be touched by fingers.
-
If the sensor is new, remove the protection cap before the sensor is pressed onto the windshield.
-
When inserting a new sensor, make sure that no air pockets are caught between the silicone and the windscreen. Air pockets could impair the
function of the sensor.
1. Clean inner area of adhesive plate.
2. Insert the electric plug connection -1- until the connector engages securely.
3. Remove the protection cap from the sensor.
4. Position the sensor -1- and insert it into the adhesive plate -2-.
