Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-120007.png)
-
Tear off the tear-off label -2- on the new component -1- and stick it under the heading Proof of airbag system check/component replacement in the
Guarantee and Maintenance booklet.
-
The replacement date and mileage must be documented and the booklet must be stamped with the dealer s stamp.
1. Insert the electric plug connection until the connector engages securely.
INFORMATION:
-
Make sure that the sensor is properly positioned.
-
Always replace the fastening screws and nuts after customer service and reworking. The micro-self-locking screws must not be treated, greased or
loosened and then screwed on again.
2. Place the sensor in position and secure using the fastening nut -1- .
-
Tightening torque: 9 Nm (6.5 ftlb.)+1 Nm (+0.5 ftlb.)-1.5 Nm (-1 ftlb.)
Subsequent work
Subsequent work for lock support sensor
1. Install front part of front wheel housing liner.
2. Connect the battery.
Subsequent work on centre sensor
1. Install left or right front door sill trim.
2. Connect the battery.
Subsequent work for wheel arch sensor
1. Install trim panel for C-pillar on left or right.
2. Connect the battery.
