Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-702002.png)
Fastening screws, front-axle support
4. Remove front-axle support -1-.
Information
PDCC chassis:
*
Steel flexi-pipes are particularly sensitive to kinking and crushing.
*
Treat the steel flexi-pipes with great care when securing the anti-roll bar.
*
Make sure that the steel flexi-pipes are not subject to any mechanical loads during the following operations.
5. Tie anti-roll bar -1- to the body using a suitable piece of wire -2- to prevent any load on the steel flexi-pipes.
Securing anti-roll bar
Installing front-axle support
Information
The anti-roll bar must be positioned before tightening the fastening screws of the anti-roll bar support (=front-axle support) so that the highest point of
the anti-roll bar is positioned at a distance from the frame support (not the fold!) of -Y- or -Z-.
The distance is:
For a normal suspension ( -Y- ) -> Control value: 93 mm.
Installation dimension of anti-roll bar
For suspension with PDCC ( -Z- ) -> Control value: 86 mm
