Panamera S (970) V8-4.8L (2010)
Preliminary work
WARNING
Mechanical, hydraulic or pneumatic press
*
Risk of squashing
-> Read specific safety information for the press.
-> Check that the press is working perfectly before use, particularly the safety components.
Information
Do not raise the wheel suspension higher than the normal vehicle position. When raising the suspension, use a suitable intermediate layer made of hard
rubber. Do not move the vehicle if drive shafts have not been fitted and tightened.
1. Remove the corresponding hub cap with puller hook 9229/1 and loosen the axle nut (lock nut) before lifting the vehicle. Operate the brake whilst
doing so (second fitter required).
2. Raise the vehicle.
3. Gently press out drive shaft, pressing out the drive shaft no more than 10 mm using the puller set Nr.87-1 Pos.1 if necessary, and set it down
carefully.
4. Remove the wheel bearing housing and set it down.
5. Remove brake disc.
6. Remove brake cover plate.
Tools and materials
Tool overview for wheel bearing