Panamera S (970) V8-4.8L (2010)
Pressing off inner wheel bearing race
Installing
Installing front wheel bearing
Component overview of wheel bearing
Component overview of front-axle wheel bearing
-1- - Wheel hub Pull off the inner race from the wheel bearing separately. Carry out a close visual inspection of the seat of the wheel hub. There
must not be scores, grooves or similar deformations on the hub.
-2- - Screw Use new screws.
-3- - Ring Circlip.
-4- - Wheel bearing The wheel bearing can no longer be used once it has been removed. Use a new wheel bearing. Do not press on the inner race.
Insert the wheel bearing with the magnetic multiple-pole ring in the direction of the drive shaft. Check the magnetic side (e.g. with a paper clip).
Do not use magnets or screwdrivers to check!
-5- - Wheel bearing housing Carry out a close visual inspection of the seat of the wheel bearing. There must not be scores, grooves or similar
deformations.
- Wheel speed sensor Should be inserted with Optitemp LG2 (25-ml spray can, Part No. 000.043.204.21).
Installing wheel bearing
1. The wheel bearing housing must be heated to approx. 80 degrees Celsius using a warming plate.