Panamera S (970) V8-4.8L (2010)
/v8-4.8l/Page-471005.png)
Removing bellows
3. Clamp the drive shaft (use aluminum protective jaws). Position an aluminum mandrel on the ball hub (star-shaped inner ring) -arrow- and remove
the joint pin (inner joint) by hitting it several times with a hammer -see illustration-.
Removing joint (transmission side)
4. Remove the hose clamps and bellows and take them off the profile shaft.
Outer joint (wheel side)
Removing bellows
5. Clamp the drive shaft (use aluminum protective jaws). Position an aluminum mandrel on the ball hub (star-shaped inner ring) -arrow- and remove
the joint pin (outer joint) by hitting it several times with a hammer -see illustration-.
