Alliance/Encore L4-1721cc 105 CID (1985)
Injector Operation
Note: The following test is to be performed on Alliance and Encore models only.
1.
With engine off, position injector ramp assembly so that each injector in turn may be placed in a suitable container.
2.
Connect a jumper wire between terminals D1-5 and D1-6, Fig. 3.
3.
Apply 12 volts and ground to each injector for short period of time.
4.
Each injector should atomize when energized and output should stop when voltage is removed. If not, replace injectors.
Fuel Pump Output
1.
Disconnect fuel tank return hose from pressure regulator and place it in suitable graduated container.
2.
Connect jumper wire between terminals D1-5 and D1-6, Fig. 3.
3.
After 1 minute, there should be a minimum of approximately 1 quart in container. If not, check fuel pump, pressure regulator, fuel filter, and
electrical circuit and repair or replace as necessary.
Fig. 3 Diagnostic connectors