Fuego L4-1565cc 95 CID (1983)
FIGURE 3
2.
Align and install the pulley on the shaft.
3.
Install snap ring 2 and 3 (Fig. 3).
NOTE:
The snap rings have a flat edge and a beveled edge on the circumference. Position the snap rings so that the flat edge is toward the compressor
and the beveled edge is outward.
4.
Install compressor shaft key 1 (Fig. 3).
5.
Install the clutch plate on the compressor shaft.
FIGURE 7
6.
Align the clutch plate keyway with the compressor shaft key and seat the plate with tool J-29641. Tap the plate onto the shaft until it bottoms on
the shims.
7.
Install and tighten the old retaining nut to 34-41 N-m (25-30 ft.lbs.) torque.
8.
Check the clearance between the pulley and the clutch: this should be between 0.4 mm (0.016 in.) and 0.8 mm (0.031 in.).
a.
If clearance is correct, remove the old nut and install a new nut. Tighten the new nut to 34-41 N-m (25-30 ft.lbs.) torque.
b.
If clearance is incorrect, remove the nut, clutch plate and shims and make up the correct thickness shim pack.
^
If clearance is excessive, remove shims.
^
If clearance is insufficient, add shims.
