Fuego L4-1565cc 95 CID (1983)
Steering Gear: Technical Service Bulletins
Power Steering - Diagnosis and Service Updates
12E107
DECEMBER 1983
RENAULT 18i AND FUEGO MODELS
POWER STEERING
Attention: Workshop, Parts Department.
DIAGNOSIS AND SERVICE UPDATES
Contents
1.
DIAGNOSIS
2.
STEERING RACK AND PINION REMOVAL/INSTALLATION
3.
PLUNGER ADJUSTMENT
4.
ROTARY VALVE SEAL AND BEARING REPLACEMENT
5.
POWER STEERING PUMP PULLEY REPLACEMENT
PRESSURE TEST DIAGNOSIS
1.
DIAGNOSIS
Pressure Testing The System
Connect pressure gauge Fre. 214-04 to the high pressure hose as follows:
1.
Disconnect the-high pressure hose from the pump.
2.
Install adapter Dir. 803 in the pump fitting and reattach the high pressure hose to the adapter.
3.
Connect pressure gauge Fre. 214-04 to the adapter.
Pressure Test Procedure
NOTE:
Be sure power steering fluid level and pump belt tension are correct before pressure testing.
^
Start and run the engine until it warms up.
^
With the engine running at idle speed, place steering wheel in straight ahead position and note gauge reading. Pressure should be at least 5 bars (72
psi) but not over 7 bars (102 psi).
^
Turn the steering wheel to a full left-turn position (against stop) and note gauge reading. Pressure should be at least 50 bars (725 psi) but not over
65 bars (943 psi). Pressure should also not differ from side-to-side by more than 5 bars (72 psi) and gauge needle should not fluctuate.