Fuego L4-2165cc 2.2L (1984)
Vacuum Brake Booster: Service and Repair
Fig. 4 Adjusting pushrod adjuster link.
1.
Remove master cylinder as previously described.
2.
Remove brake pedal pushrod adjusting pin.
3.
Remove brake booster attaching nuts.
4.
Remove brake booster, retaining support spacer.
5.
Adjust master cylinder clearance by adjusting piston rod nut to obtain a clearance of .354 in. between end of piston rod and master cylinder
mounting face.
6.
Adjust pushrod adjuster link (C), Fig. 4, on brake pedal side by unscrewing locknut (E) until dimension (L) equals 5.063 in.
7.
Assemble master cylinder and support spacer on power booster.
8.
Install and attach entire assembly, then install brake pedal pin.
9.
Reconnect vacuum hose pushrod adjuster link to booster.
10.
Reconnect brake lines to master cylinder, ensuring correct location.