9-2X F4-2.5L (2006)
Electronic Brake Control Module: Service and Repair
ABS Control Module And Hydraulic Control Unit (ABSCM&H/U)
REMOVAL
Disconnect the ground cable from battery.
Remove the air intake duct and air cleaner case from the engine compartment to facilitate removal of ABSCM&H/U.
Use compressed air to get rid of water around the ABSCM&H/U.
Note: Contact will be insufficient if the terminal gets wet.
Disconnect the ABSCM&H/U connector pulling up the lock lever.
Important: Do not pull the harness when disconnecting connector.
Remove the harness clip.
Disconnect the brake pipes from ABSCM&H/U.
Wrap the brake pipe using a vinyl bag not to spill the brake fluid on the vehicle body.
Important: When brake fluid is attached to the vehicle body, wash it off with water and wipe the water.
Remove the nuts and remove the ABSCM&H/U.
Important:
^
Do not drop or bump the ABSCM&H/U.
^
Do not turn ABSCM&H/U upside down or place it sideways for storage.
^
Be careful that no foreign objects are mixed in ABSCM&H/U.
^
Be careful that no water enters inside the connectors.
Remove the ABSCM&H/U bracket.
INSTALLATION
Install the ABSCM&H/U bracket.
Tightening torque: 33 Nm (3.3 kgf-m, 24 ft. lbs.)
Install the ABSCM&H/U aligning the groove of damper on ABSCM&H/U side with the pawl of bracket.
Note: Check the identification mark of ABSCM&H/U.
