saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Extension Case Oil Seal|Page 3083 > < Control Module, A/T|Service and Repair
Page 1
background image

Seals and Gaskets: Service and Repair
Extension Case Oil Seal

Extension Case Oil Seal 

INSPECTION 

Make sure the ATF does not leak from the joint of transmission and propeller shaft. If so, replace the oil seal. 

REPLACEMENT 

1. Clean the transmission exterior.
2. Drain the ATF completely.

NOTE: 

^

Tighten the ATF drain plug after draining the ATF.

^

Use anew gasket.

3. Remove the rear exhaust pipe and muffler.

Non-turbo model 
Turbo model

4. Remove the propeller shaft. 
5. Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
6. Using the ST, install the oil seal.
ST 498057300 INSTALLER
7. Install the propeller shaft. 
8. Install the rear exhaust pipe and muffler. 

Non-turbo model
Turbo model 

9. Pour ATF and check the ATF level.

Extension Case Oil Seal|Page 3083 > < Control Module, A/T|Service and Repair