9-3 (9440) L4-2.0L Turbo (2007)
Rear Shelf: Service and Repair
Crossmember, CV
Crossmember, CV
1. Position the car in an aligning bench and cross-measure if necessary.
2. Remove the Bootlid and Soft top cover.
3. Cut the crossmember 30 mm from the outer edge of the upper panel on both sides. Lift aside the crossmember.
4. Drill out the upper spot welds to the lower crossmember panel on the relevant side.
5. Drill out the lower spot welds to the lower crossmember panel on the relevant side.