9-3 (9440) L4-2.0L Turbo (2007)
/l4-2.0l_turbo/Page-1199026.png)
18. Position the fitting tool on the crankshaft. Tighten the sealing ring using the crankshaft pulley bolt until it is flush with the timing cover. Remove
the tool.
19. Fit the crankshaft pulley with a new bolt. Use 83 95 360 Holding tool, crankshaft pulley (shaft only) and 83 96 210 Holding tool, crankshaft
pulley, B207.
Tightening torque 100 Nm + 75 degrees (74 ft. lbs. + 75 degrees)
20. Check that the markings on the crankshaft pulley and the timing cover are aligned. Tighten the camshaft gears a first time. Use a spanner to grip
the camshaft flats.
Tightening torque 30 Nm (22 ft. lbs.)
