9-3 (9440) L4-2.0L Turbo (2007)
17. Remove the adjustment tools and fit the bearing caps (B).
Tightening torque 8 Nm (6 ft. lbs.)
18. Continue to tighten the camshaft gears to the final torque. Use a wrench to grip the camshaft flats (A).
Tightening torque 85 Nm + 30 degrees (63 ft. lbs. + 30 degrees)
19. Rotate the crankshaft 2 turns in the direction of engine rotation until the mark on the crankshaft pulley agrees with the mark on the timing cover.
Remove the bearing caps and fit EN-48368 Adjustment tool, camshaft (B207 210 hp) and EN48366 Adjustment tool, camshaft (B207, 150 - 175
hp) again to check that the camshaft setting is correct. Remove the adjustment tools and refit the bearing caps.
Tightening torque 8 Nm (6 ft. lbs.)
20. Fit the upper timing chain guide rail (C).
21. Fit the Camshaft cover with gasket
22. Lower the car completely.
23. Check engine oil level. Top up as necessary.